LCD screen to monitor boost pressure in real time. Readout now in kPa or PSI. (100kPa = 1.01972kg/cm2 = 1.5psi)

Controls boost up to 43 psi (This may vary on different turbo systems)

There are 2 preset settings that can be selected by a single switch. The response and the consistency of the boost can be adjusted by using the GAIN, START BOOST setting. A built in warning feature will alert the driver when the boost exceeds the set boost pressure with an alarm and a message in the display. When the warning feature is activated, the LIMITER feature can lower the boost to a safe pressure. PEAK boost feature will allow the user to check the highest boost recorded.

The original lower cost solution for most turbo systems. A no frills, super accurate, GReddy quality boost controller without Fuzzy Logic (which many believe is the best way to go on the sequential turbo set-up). If you want an outstanding lower cost boost controller, you might as well procure the Profec B from the world leader in Turbo performance products, GReddy.

SETUP

Hands down the most simple controller on the market. By adjusting the Hi and Lo knobs, the user is able to adjust boost pressure. Adjusting the balance knob will increase or decrease turbo response. No setup is needed, no learning required, and it is very user friendly.